3 Review(s)

How to Install: 1. Use the tape measure to measure the surface. And then cut the wallpaper into right size, leaving about 5cm extra overlap on all edges is better. You can cut the desired size according to the trimming gridlines which on the back of wallpaper. 2. Peel off the wallpaper, and then apply the wallpaper on the surface edges. Tearing off the backing paper on the same direction. 3. Continue applying the contact paper to the surface horizontally and smoothing with a soft cloth or paddle beginning from the center to edges little by little. 4. If you still find a few air bubbles keep popping up after attached the wallpaper, you can just use a tiny needle or the point of the knife to poke the air out lightly, and this will disappear no trace. 5. For round edges install, it will need to put additional glue on the edges for installation, and heat it with hair dryer(8cm~10cm away from the wall paper). Smart Tip: 1. Surfaces covered with Yenhome product can be washed and maintained with warm soapy water and can be easily changed for new designs. 2. Be sure to wipe down your wall to remove dust and grime prior to application! Apply to smooth surfaces for best results. 3. Do not apply near high-heat locations (e.g. less than 30cm to fire) as the material may warp, bubble, and peel.