3 Review(s)

AUTOMATIC SYSTEM FOR PUMPING WATER FROM BASEMENT (SUMP) TANK FOR SINGLE PHASE UP TO 2 HP MONO-BLOCK PUMP MOTORS FULLY AUTOMATIC FUNCTIONS: This system activates single phase up to 2 HP pump motor when water level in basement (sump) tank fully fills up and switches off pump motor when water in the said sump tank finishes. OPTION FOR INSTANT PUMP MOTOR START: This system also has an option for starting the pump motor manually by soft press button before water level in basement (sump) tank reaches the prefixed level for automatic switch on the motor but, it will switch off the motor automatically when water in basement (sump) tank is finished. However, this function will not activate pump when there is enough water in the basement tank, which may vary according to setting of sensor-switch for on & off levels in tank. MAINTENANCE-FREE SENSOR-SWITCH: The system has maintenance-free sensor-switch, concealed in a plastic casing, which senses water levels in tank without passing any electric current into the water, thus, doing away with the hassles of maintenance due to absence of chemical reactions that may cause oxidation to the sensor-switch. Range/distance between sensor-switches & controller should not be more than 200 feet. EASY TO INSTALL: The system is very easy to install as it has only one sensor- switch in tank which can be connected, colour-wise, as per sticker pasted above the connectors of system. This system can be connected to control single phase pump motor (up to 2 H.P.) as per the connection diagram mentioned in the operator’s manual. LED Indicators: The system has LED light indicators for pump function, standby/power. This system is also suitable for pump motor up to 2 HP with single phase starters having only a run capacitor. NOTE: Wire for connecting tanks with controller is not included in the package. Please use proper .5 mm (3 core) wire for this purpose. CAUTION: THIS IS A 220 VOLT DEVICE, MUST BE INSTALLED BY AN ELECTRICIAN ONLY.