3 Review(s)

Water Level Controller For Submersible Pump Motor Starter Panels By Me-Tech Innovations Mohali Full Automatic Functions: This meticulously designed system energizes the submersible pump motor starter as soon as water level in overhead tank goes below the programed/pre-fixed/pre-set point, and switches off the motor starter immediately when over head tank fully fills up. It will also switch off pump motor when lower (Reservoir) tank runs out of water. This way the system, not only saves water, manpower & electric energy but also enhances the life of pump motor. Option For Instant Pump Motor Start: The system also has the option for starting the pump motor manually with one soft touch/press button, before the water level in the overhead tank reaches the prefixed/programmed level for automatic switching-on. But, it will switch off the said motor automatically as soon as the overhead water tank fully fills up. This way the system helps in storing maximum quantity of water when there is limited period (timing) of electric supply is available. For example: There is a power cut and electric supply is available for two hours & during this time, the water level in overhead tank is not at prefixed level for switching on the pump motor, and by the time, water level in the overhead tank reaches the prefixed level for switch-on, the time of availability of electric supply runs out. Resultantly, the overhead tank may not get filled up. But the option for manually switching on the pump motor at the time of availability of electricity will help in filling maximum quantity of water in the overhead tank. However, this function will not activate pump motor if there is sufficient quantity of water in overhead tank. The said quantity of water for using this option may vary according to the setting/adjustment of sensor for switch on & off levels in overhead tank. Maintenance Free Sensors: The system, in strong shock-proof ABS cabinet, has maintenance free sensor-switches which sense water levels in tanks without passing any electric current into the water, thus, doing away with the hassles of maintenance due to absence of chemical reactions or corrosion/oxidations to these sensors. Easy to Install: The system is very easy to install as it has only one sensor in each tank. The system is designed to control the starter with 2-3 second automatic resettable timer,which triggers the starter’s “switch on’ button for 2-3 seconds only. This way system disconnects the capacitors, connected for starting the motor, in 2-3 seconds after the motor takes its full running speed. LED Indications: The system has LED indications for pump function & standby/power.