3 Review(s)

Rubber seal Car Door Edge Guards contains a higher concentration of EPDM than other brands which means it will last longer and much stronger!The rubber is embedded with stainless steel steel, which can be installed without glue, and will not leave marks when removed. Specification: Material: Rubber,Stainless Steel Length: 5m/16.4ft Color: Black Width: 10mm Edge Thickness: 2mm Grip Range: 1.0mm to 2.5mm Features: Seal the gap of the door to prevent dust from entering the car. Prevent air conditioning leaks and improve energy efficiency. Avoid hitting the car next to the wall goods when opening the door. Easy install.(Direct replacement. Just push on the rubber seal above the install place.) Isolator noise, corrosion resistance, high temperature resistance, wear resistance, anti-aging, UV resistance,Fully waterproof?Its durability will definitely surprise you! Methods of Installation: Clean the door edge of your car to remove any oil, wax and dust. Make sure the door is dry before continuing. Uncover the tape from the tip of the lining (Ensure the tape is install INSIDE the door) and peel the red strip off the tape by approximately 2 inches. Start from the top, insert the lining onto your door edge until the lining is fully seated. Press the lining with your thumb along the door edge until it is fully seated, then pull the red strip off. Repeat step 4 until all edges are protected. Use scissors to cut away unused lining for other door edges. Let the lining dry up by itself and do not get wet for at least 12 hours.