3 Review(s)

STEP-BY-STEP INSTALLATION INSTRUCTIONS: 1.Measure and record the dimensions the target glass. 2.Clean the glass thoroughly: make sure no residue dust remains, or it will make too much bubbles during the installation. 3.Add 1+ inch on every side when cutting the film so you have excess film to trim away. 4. Peel off the backing liner: If it is difficult to find the clear protective film ,use the sticker tape to help you find it. 5.Generously spray the soapy water or pure water both on the glass and the window film. 6.Place the film on the wet glass, adjust the position of the window film. 7. Using a plastic squeegee or card,beqin squeegeeing the water and air out from under the film. 8.Trim excess material away with a VERY sharp razor or craft knife, leaving a 1/16" wide gap around the edges of the film. 9.Finish. SELLER TIPS: 1. The adhesive effect of the film may not be good in winter. Solution: before application, use hair dryer to make it soft( heat resistance is under 176°F) 2. Fit for smooth surface without any dust or fiber. 3. Do not apply to outside window or windows with cracks. 4. More efficient in teamwork. 5. Affix tape on both sides to remove the window film from backing film. *Only Applies on Smooth Glass Surfaces*